Install Wiring Management Kit
Installation of the Wiring Management Kit consists of unpacking and inspecting the kit for signs of obvious damage, and return or
replace as necessary, and placement of the unit on the Main Housing Chassis. Secure the kit to the chassis by placing the alignment
pins (Figure 10) with the holes provided in the top of the Main Housing Chassis, and pushing straight downward until all four
retaining pins are fully seated.
Figure 10. Wiring Management Kit Installation
Section 4. Controls and Indicators
Please review this section thoroughly before applying power to the Power Inverter.
Inverter Controls - Controls provided on the Power Inverter consist of the holiday mode switch marked AWAY/HOME, and the
Tes t/Mu te switch, as well as a rear panel Push to Reset circuit breaker, and are defined in the following:
AWAY/HOME - (also known as the holiday mode switch) - In the HOME position, this two-position rocker switch (Figure 11) sets
the Inverter so that it will switch to battery output when there is a utility power outage.
In the AWAY position, the Inverter goes into standby mode and will not switch to battery power in the event of a power outtage.
This is to conserve the batteries. However, in this position, the Inverter will charge the batteries until a utility power failure occurs.
TEST/MUTE - In TEST mode, when ON MAINS LED is lit, on pressing this push button, the unit will do self test to determine
the state of the system. During On Battery self test it will also show the load status which can be used to find out the load capacity.
In the MUTE position (push in for 5 seconds), this push button switch silences the low battery buzzer.
Circuit Breaker Switch (Rear Panel) - When in ON MAINS mode, if the system draws more than 10A, circuit breaker will trip. To
reset the circuit breaker switch, push the switch fully inward.
Inverter Indicators - The Inverter provides light emitting diode (LED) indicators (Figure 11) to show the operational condition of
the Inverter and batteries. Indicators consist of Inverter Load Status (25%, 50%, 75%, 100%, and OVER LOAD). Other
indicators consist of: INVERTER DISABLE, ON MAINS, ON BATTERY, and FAULT). Using Table 1, determine the condition
of the Inverter and batteries.
Page 9
Wiring Management
Kit
Holes (4 places)
Alignment Pins
(4 places)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals