Quick Configuration
12 Switched Rack PDU Installation and Quick Start
3. Use Telnet to access the Rack PDU at its newly assigned IP
address. For example:
telnet 156.205.14.141
4. Use apc for both user name and password.
5. See “Control console” on this page to finish the configuration.
Control console
After you log on at the control console, as described in “Local access to
the control console” on page 11 or “Remote access to the control
console” on page 11:
1. Choose Network from the Control Console menu.
2. Choose TCP/IP
from the Network menu.
3. If you are not using a BOOTP or DHCP server to configure the
TCP/IP settings, select the Boot Mode menu. Select Manual boot
mode, and then press
ESC to return to the TCP/IP menu. (Changes
will take effect when you log out.)
4. Set the System
IP, Subnet Mask, and Default Gateway address
values.
5. Press
CTRL-C to exit to the Control Console menu.
6. Log out (option 4 in the Control Console menu).
Note
If you disconnected a cable during the procedure
described in “Local access to the control console” on
page 11, reconnect that cable and restart the associated
service.
Comments to this Manuals